Ip Igmp Access-Group - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Default
Command
mode
Usage
guidelines
Examples
38.1.3

ip igmp access-group

Use this command to control a multicast group on the interface. The no form of this
command disables this function.
Command
syntax
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
N/A All interfaces
N/A.
Privileged mode.
This command is used to clear the information on the interface that is
generated when IGMP is configured. The ifname parameter can be
ignored.
DES-7210# clear ip igmp interface gigabitEthernet 4/1
ip igmp access-group access-list
no ip igmp access-group
Parameter Description
Name of access control list within the range of 1
access-list
to 199, 1300 to 2699, or characters.
Filtering conditions are not set.
Interface configuration mode.
You can add some interfaces of the host in a subnet to multiple
multicast groups. These multicast groups can be controlled using ip
igmp access-group.
In the following example, the host service can only add the interface
GigabitEthernet 4/1 to the group 225.2.2.2 .
DES-7210# configure terminal
DES-7210(config)# access-list 1 permit 225.2.2.2 0.0.0.0
Chapter 38 IGMP Configuration Commands
38-3