Show Arp-Guard Users - D-Link DES-7200 Cli Reference Manual

Chapter 53 NFPP Configuration Commands
commands
53.2.2

show arp-guard users

Use this command to show the isolated usres.
show arp-guard users [statistics | [[vlan vid] [interface interface-id] [ip-address |
mac-address]]]
Parameter
description
Command
mode
Examples
53-10
arp-guard
Configure the arp-guard isolate time.
isolate timeout
arp-guard
Configure the arp-guard rate limit.
rate-limit
arp-guard Configure
attack-threshold threshold.
Configure
arp-guard
scan-threshold threshold.
Parameter Description
statistics Show the statistics of the isolated users.
vid VLAN ID.
interface-id Interface name and interface id.
ip-address The IP address.
mac-address The MAC address.
Privileged EXEC mode.
The following example shows the statistics of the isolated users:
DES-7210# show arp-guard users statistics
Success: 100
Fail: 1
----------------
Total: 101
101 users are isolated, and 100 users have been isolated by the
hardware successfully. That is to say, only one user failed due to
insufficient memory or the hardware resources.
The following example shows how to show the isolated users. The
DES-7200 CLI Reference Guide
the arp-guard attack
the arp-guard scan