D-Link DES-7200 Cli Reference Manual page 1028

Chapter 54 ACL Configuration Commands
source-ipv6-address | any}[operator port[port]] {destination-ipv6-prefix /prefix-length |
host destination-ipv6-address | any} [operator port
[port]] [dscp dscp] [flow-label flow-label] [fragments] [time-range
time-range-name] [match-all tcp-flag]

User Datagram Protocol (UDP)
[sn] deny udp {source-ipv6-prefix/prefix-length | host
source-ipv6-address | any} [operator port [port]]
{destination-ipv6-prefix /prefix-length | host destination-ipv6-address |
any}[operator port [port]] [dscp dscp] [flow-label flow-label]
[fragments] [time-range time-range-name]
For the parameters that are not mentioned below, please refer to the access-list.
Parameter
description
Default
configuration
Command
mode
54-20
Parameter
Sn
source-ipv6-prefix
destination-ipv6-prefix
prefix-length
source-ipv6-address
destination-ipv6-address
dscp
dscp
flow-label
flow-label
protocol
N/A.
ACL configuration mode.
DES-7200 CLI Reference Guide
Description
ACL entry sequence number
Source IPv6 network address or network
type
Destination IPv6 network address or
network type
Prefix mask length
Source IPv6 address
Destination IPv6 address
Differential Service Code Point
Code value, within the range of 0 to 63
Flow label
Flow label value, within the range of 0 to
1048575.
For the IPv6, the field can be ipv6 | icmp |
tcp | udp and number in the range 0 to 255