Ip Igmp Limit (Interface Configuration) - D-Link DES-7200 Cli Reference Manual

Chapter 38 IGMP Configuration Commands
Examples
Related
commands
38.1.9

ip igmp limit (interface configuration)

Use this command to set the maximum number of IGMP states on the interface. Use the no
form of this command to remove the setting.
Command
syntax
Parameter
description
Default
Command
mode
Usage
guidelines
38-8
member report is received within the waiting time.
The following example sets the interval of sending the group query
message to 20 seconds:
DES-7210# configure terminal
DES-7210(config)# interface eth 0
DES-7210(config-if)# ip igmp last-member-query-interval 200
ip igmp immediate-leave.
ip igmp limit number [except access-list]
no ip igmp limit
Parameter Description
Maximum number of IGMP states, depending on
number
devices, 1-16384
(Optional) Prevent the groups of the access list
except from taking part in calculation, which is not
limited by maximum number..
access-list (Optional) Access list
1024
Interface configuration mode.
This command in global configuration mode limits the number of the
IGMP group members. The messages of the members over the limit
are not recorded and processed.
This command can be configured globally or on the interface The
messages of the members will be ignored if they exceed the interface
or global configuration.
DES-7200 CLI Reference Guide