Router Rip - D-Link DES-7200 Cli Reference Manual

Hide thumbs Also See for DES-7200:

Table of Contents

Chapter 31 RIP Configuration Commands

31.1.26 router rip

Use this command to create the RIP routing process and enter into the routing process

configuration mode. The no form of this command is used to delete the RIP routing process.

no router rip

This command redistributes external routes.

It is not necessary to convert the metric of one routing protocol into

that of another routing protocol for route distribution, since different

routing protocols use different metric measurement methods. The

RIP protocol calculates metric on hop, the OSPF on bandwidth. So

their metrics are not comparable. However, a symbolic metric must

be set for route redistribution. Otherwise, route redistribution will fail.

When you configure ISIS routes redistribution without the level

parameter, only level-2 routes are redistributed by default. If the

redistribution configuration is initialize with level parameter, then all

routes with level configured are redistributed.

When you configure redistributing OSPF routes without the match

parameter, the OSPF routes of all sub types are redistributed by

default. Then the first configured match parameter is used as the

original one. Only the routes matching the specific type can be

redistributed. The no form of this command restores the setting to the

default value.

The redistribute command cannot redistribute the default route of

other protocol to the RIP process. To this end, execute the

default-information originate command.

Redistribute static routes.

DES-7210(config-router)# redistribute static

default-metric

DES-7200 CLI Reference Guide

Set the default metric of the route to be

redistributed.