Sntp Server; Sntp Interval - D-Link DES-7200 Cli Reference Manual

Chapter 26 SNTP Configuration Commands
26.1.2

sntp server

Use this command to set the SNTP server. Since the SNTP protocol is completely
compatible with the NTP protocol, you can configure the SNTP server as the public NTP
server on the Internet.
sntp server ip-addr
no sntp server
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
26.1.3

sntp interval

Use this command to set the interval for the SNTP Client to synchronize its clock with the
NTP/SNTP Server.
Note that the set interval will not take effect immediately. To this end, execute the sntp
enable command after setting the interval.
sntp interva seconds
no sntp interval
Parameter
description
26-2
Parameter Description
ip-addr The IP address of the NTP/SNTP server.
N/A.
Global configuration mode.
The show sntp command shows the parameters of SNTP.
DES-7210(config)# sntp server 192.168.4.12
Command Description
show sntp Show the SNTP configuration.
sntp enable Enable SNTP.
Parameter Description
seconds Synchronization interval in 60 to 65535
DES-7200 CLI Reference Guide