Mpls Static L3Vpn-Ftn - D-Link DES-7200 Cli Reference Manual

Chapter 42 MPLS Configuration Commands
Related
commands

42.1.27 mpls static l3vpn-ftn

Use this command to add the FTN of one L3 VPN. Use the no form of this command to
delete this FTN.
mpls static l3vpn-ftn
mpls static l3vpn-ftn
nexthop-ip
no mpls static l3vpn-ftn
Parameter
description
Command
mode
42-26
Command
show mpls
forwarding-table
vrf-name A.B.C.D/Mask
vrf-name A.B.C.D/Mask
vrf A.B.C.D/Mask
Parameter
vrf-name
A.B.C.D/Mask
out-label label
remote-pe ip-addr
local-forward
nexthop
interface-name
nexthop-ip
Global configuration mode.
DES-7200 CLI Reference Guide
Description
Show the overview information of the global
FTN table
out-label remote-pe
label
local-forward nexthop interface
Description
Specify the name of the VRF whose FTN table
to which the FTN entry is to be added
Fec, namely the destination
network.
It indicates that the corresponding private
network FTN should reach to other PE
forwarding through the LSP tunnel. At the
same time, it will be specified with the private
network label used for the forward.
The address of the egress PE.
It indicates that the corresponding private
network FTN will be forwarded to the next hop
by this PE directly. At the same time, it will
specify the egress of the next hop and the IP
address.
ip-addr