D-Link DES-7200 Cli Reference Manual page 279

DES-7200 CLI Reference Guide
no client-identifier
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
Related
commands
Parameter
unique-identifier
N/A.
DHCP address pool configuration mode.
When some DHCP clients request the DHCP server to assign
IP addresses, they use their client IDs rather then their
hardware addresses. The client ID consists of media type,
MAC address and interface name. For instance, the MAC
address is 00d0.f822.33b4,
GigabitEthernet 0/1, and the corresponding client ID is
0100.d0f8.2233.b467.6967.6162.6974.4574.6865.726e.6574.
302f.31, where, 01 denotes the type of the Ethernet media.
The 67.6967.6162.6974.4574.6865.726e.6574.302f.31 is the
hex code of GigabitEthernet0/1. For the definition of the media
code, refer to the Address Resolution Protocol Parameters
section in RFC1700.
This command is used only when the DHCP is defined by
manual binding.
The configuration example below defines the client ID of the Ethernet
DHCP client whose MAC address is 00d0.f822.33b4.
client-identifier
0100.d0f8.2233.b467.6967.6162.6974.4574.6865.726e.6574.302f.31
Command
hardware-address
host
Chapter 23 DHCP Configuration Commands
Description
The DHCP client ID, indicated in hex
and separated by dot, for instance,
0100.d0f8.2233.b467.6967.6162.6974.
4574.6865.726e.6574.302f.31.
the interface
Description
Define the hardware address of DHCP client.
Define the IP address and network mask,
which is used to configure the DHCP manual
binding.
name is
23-3