Show Ip Rip Database - D-Link DES-7200 Cli Reference Manual

Chapter 31 RIP Configuration Commands
31.2.2

show ip rip database

Use this command to show the summary address entries in the RIP routing database.
show ip rip database [vrf vrf-name] [network-number {network-mask}]
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
31-36
Follwoing example specifies vrf and displays the corresponding basic
information of RIP instance:
DES-7210(config-router)# sh ip rip vrf 1
VRF 1 VRF-id:1
Routing Protocol is "rip"
Sending updates every 30 seconds, next due in 4 seconds
Invalid after 180 seconds, flushed after 120 seconds
Outgoing update filter list for all interface is: not set
Incoming update filter list for all interface is: not set
Default redistribution metric is 1
Redistributing:
Default version control: send version 1, receive any version
Routing for Networks:
Distance: (default is 120)
Parameter Description
(Optional) Show the RIP routing information of
vrf vrf-name
specified VRF.
network-number (Optional) Network number
network-mask Subnet maskIt if the network number is specified.
N/A.
Privileged mode, global configuration mode, routing process
configuration mode.
Only when the related sub-routes are converged, the converged
address entries appear in the RIP routing database. When the last
sub-route information in the converged address entries becomes
invalid, the converged address information will be deleted from the
database.
In the configuration example below, all converged address entries in
the RIP routing database are displayed.
DES-7210 # show ip rip database
192.168.1.0/24
DES-7200 CLI Reference Guide
auto-summary