Tunnel Ttl - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Command
mode
Usage
guidelines
Examples
Related
commands

36.1.24 tunnel ttl

Use this command to specify the TTL value of the IPv4 header in the encapsulated IPv6
messages. The no form of this command restores it to the default.
tunnel ttl value
no tunnel ttl
Parameter
description
Default
configuration
Command
mode
Interface configuration mode.
The source IP address of a tunnel can be a specified IPv4 address or
an IPv4 address of an interface. When you configure an auto tunnel
(for example, 6to4 and isatap), it is recommended to specify the
source address.
A device shall not be configured multiple tunnels with the same
encapsulation type, source address and destination address.
If there are multiple auto tunnels, their source addresses shall be
different.
The following example configures an IPv6 manual tunnel.
DES-7210(config)# interface tunnel 1
DES-7210(config-if)# tunnel mode ipv6ip
DES-7210(config-if)# tunnel source vlan 1
DES-7210(config-if)# tunnel destination 192.168.5.1
Command Description
tunnel mode Configure the mode of a tunnel.
tunnel
Configure the destination address of a tunnel.
destination
Tunnel ttl Configure the TTL of the tunnel.
Parameter Description
value TTL value
The default value is 128.
Interface configuration mode.
Chapter 36 IPv6 Configuration Commands
36-21