Target-Session Holdtime - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Related
commands

42.1.40 target-session holdtime

Use this command to set the keepalive holdtime for the extended mechanism. Use the no
form of this command to restore the default value.
target-session holdtime
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
GigabitEthernet 4/2
Total number of mpls interface is 2
Command
label-switching
seconds
Parameter
seconds
By default, the holdtime of the LDP session built in the extended
discovery mechanism is 180s. The sending interval of the keepalive
message is 60s, which is 1/3 of the session holdtime.
config-mpls-router mode.
Note that this command is valid for the LDP session only built in the
extended discovery mechanism, not for the LDP session already set
up.
DES-7210(config)#mpls router ldp
DES-7210(config-mpls-router)# target-session holdtime 90
Chapter 42 MPLS Configuration Commands
0
Description
Enable label switching
Description
Set the holdtime, with the value range
<15-65535>.
42-41