Clear Ip Ospf Process - D-Link DES-7200 Cli Reference Manual

Hide thumbs Also See for DES-7200:

Table of Contents

Chapter 32 OSPFv2 Configuration Commands

32.1.10 clear ip ospf process

Use this command to clear and restart the OSPF instance.

clear ip ospf (process-id) process

100Mbps by default.

Routing process configuration mode.

This command sets the reference bandwidth for automatically

generating interface cost. No parameter with it enables the automatic

cost function with a default for the reference bandwidth. A parameter

with it enables the automatic cost calculation function with a specified

reference bandwidth. Note that the "default auto-cost" and the "no

auto-cost" are different: the former restores it to the default and

enables the automatic cost function while the latter disables the

automatic cost calculation function.

If you use ip ospf cost command to set the cost of the interface, the

cost will replace the auto-cost.

The configuration example below configures the reference bandwidth

DES-7210(config)# router ospf 1

DES-7210(config-router)# network 172.16.10.0 0.0.0.255 area 0

DES-7210(config-router)# auto-cost reference-bandwidth 10

Show the OSPF global configuration information

show ip ospf

OSPF instance ID

When no process ID is specified, the command

clears and restarts all the running OSPF

Use the rule recommended in RFC 1583 by default.

DES-7200 CLI Reference Guide