Show Ip Interface - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Examples
Platform
description
21.4.7

show ip interface

Use this command to show the IP status information of an interface. The command format is
as follows:
show ip interface [ interface-type interface-number ]
Parameter
description
Command
mode
The following is the output of show ip arp:
DES-7210# show ip arp
Protocol Address
Internet 192.168.7.233 23
Internet 192.168.7.112 10
Internet 192.168.7.79
Internet 192.168.7.1
Internet 192.168.7.215 36
Internet 192.168.7.127 0
Internet 192.168.7.195 57
Internet 192.168.7.183 --
Each field in the ARP cache table has the following meanings:
Field Description
Protocol Network address protocol, always Internet.
The IP address corresponding to the hardware
Address
address.
Age of the ARP cache record, in minutes; If it is not
Age (min) locally or statically configured, the value of the field
is represented with ―-‖.
Hardware Hardware address corresponding to the IP address
The type of hardware address. The value is ARPA
Type
for all Ethernet addresses.
Interface Interface associated with the IP address.
This command is not supported on the Layer 2 switch.
Parameter Description
interface-type Specify interface type.
interface-number Specify interface number.
Privileged mode.
Chapter 21 IP Address Configuration Commands
Age(min)Hardware
0007.e9d9.0488 ARPA FastEthernet 0/0
0050.eb08.6617 ARPA FastEthernet 0/0
12 00d0.f808.3d5c ARPA FastEthernet 0/0
50 00d0.f84e.1c7f ARPA FastEthernet 0/0
00d0.f80d.1090 ARPA FastEthernet 0/0
0060.97bd.ebee ARPA FastEthernet 0/0
0060.97bd.ef2d ARPA FastEthernet 0/0
00d0.f8fb.108b ARPA FastEthernet 0/0
Type Interface
21-21