Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for D-Link DES-7210-BASE
Summary of Contents for D-Link DES-7210-BASE
- Page 1 Building Networks for Peopl e Quick Installation Guide 6/10 Slot Chassis-Based Switch This document will guide you through the basic installation process for your new D-Link chassis-based switch. DES-7200 Documentation also available on CD and via the D-Link Website...
-
Page 2: About This Guide
About This Guide Warnings This guide contains step-by-step instructions Power Supply Safety Warning for setting up the D-Link DES-7200 Series Ground the device before powering Switch Chassis. Please note that the model on to guard against power surges. you have purchased may appear slightly different from those shown in the illustrations. -
Page 3: Preparation For Installation
Preparation For Installation Moving the Device To ensure normal operation and prolonged The DES-7200 is large and heavy. When life of the DES-7200, the appropriate temper- handling, please pay close attention to the ature and humidity must be maintained in the following guidelines: equipment room. - Page 4 Tolerance range: 90-176VAC, 47-53Hz 1200W 176-264VAC, 57-63Hz 2000W Total power: 2000W When DES-7200 uses the DC power supply: 7200-1200DC Rated voltage: -48VDC Tolerance range: Total Power: 1200W 7200-2000DC Rated voltage: -48VDC Tolerance range: Total Power: 2000W D-Link 6/10 Slot Chassis-Based Switch...
-
Page 5: Installation Site Requirements
Ensure that the dimensions of the cabinet Requirements of Installation Tools provide enough space for the installation of Type Tools Remarks the front, rear, left and right panels of the DES-7200 for the sake of heat dissipation. Unpack wooden Claw hammer, case and transpor- pliers The frame should be properly grounded. - Page 6 Figure 7. Installing the Power Supply with a Phillips-head screwdriver, as shown in of the DES-7210 and DES-7206 Figure 5. Figure 5. Installing the Power Supply of the DES-7210 and DES-7206 D-Link 6/10 Slot Chassis-Based Switch...
- Page 7 Installing the Handle To ease handling of the system, the DES-7200 chassis is provided with a handle, which can be installed by carrying out the following steps: Align the handle with the sunk hole on the fastening bar. Tighten the M4 sunk crosshead screws provided with the unit, as shown in Figure 8.
- Page 8 DC power module and the wiring shown in the following diagram. Figure 13. Schematic Diagram for the Connection of the AC Power Cable Figure 12. Schematic Diagram for the Connection of the DC Power Cable D-Link 6/10 Slot Chassis-Based Switch...
- Page 9 Precautions Warning: Before connecting the power supply, you Always wear an anti-static wrist strap before must verify that the external power supply plugging in or unplugging a board. provided matches the power module installed in this equipment. collide the components on the PCB. Before connecting the power cable, you must ensure that the switch of the power module is in the OFF position.
-
Page 10: Unpacking Inspection Requirements
A terminal or a computer with both a serial documentation for the DES-7200. port and the ability to emulate a terminal. A null modem or crossover RS-232 cable with a female DB-9 connector for the console port on the Switch. D-Link 6/10 Slot Chassis-Based Switch... -
Page 11: Additional Information
Set the terminal emulation software as to help you get your network up and running. follows: Baud rate: 9600 listed online. To learn more about D-Link Data bits: 8 products or marketing information, please visit Parity: None the website http://www.dlink.com.tw; for any...