Mpls Mtu - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Command
mode
Examples
Related
commands

42.1.24 mpls mtu

Use this command to configure the MTU value when the MPLS messages are forwarded.
mpls mtu
no mpls mtu
Parameter
description
Usage
guidelines
Default
configuration
config-mpls-router mode.
DES-7210(config-mpls-router)# transport-address 192.168.0.1
Command
show mpls
parameters
<64-6535>
Parameter
<64-65535>
The path vector value is valid with the loop detection of the LDP
instance enabled. If the LDR ID number, that is in the path vector list
of the label mapping message or the label request message of LDP, is
greater than the configured value, it is deemed that a loop occurs. This
command is invalid for the built LDP session, but influences the LDP
session to be built.
The MPLS MTU value equals to the interface MTU and the length of 2
labels.
Chapter 42 MPLS Configuration Commands
Description
ldp
Show all LDP parameters globally.
Description
The mtu value supported by the interface, in
byte.
42-23