Radius-Server Host - D-Link DES-7200 Cli Reference Manual

Chapter 46 RADIUS Configuration Commands
Usage
guidelines
Examples
Related
commands
46.1.2

radius-server host

Use this command to specify a RADIUS security server host. The no form of this command
is used to delete the RADIUS security server host.
radius-server host {hostname | ip-address} [auth-port port-number] [acct-port
port-number]
no radius-server host {hostname | ip-address}
Parameter
description
46-2
In order to reduce the NAS information to be maintained on the
RADIUS server, use this command to set the source IP address of
the RADIUS packet. This command uses the first IP address of the
specified interface as the source IP address of the RADIUS packet.
This command is used in the layer 3 devices.
The following example specifies that the RADIUS packet obtains an
IP address from the fastEthernet 0/0 interface and uses it as the
source IP address of the RADIUS packet:
DES-7210(config)# ip radius source-interface fastEthernet 0/0
Command Description
radius-server
Define the RADIUS server.
host
Configure the IP address of the interface.
ip address
Parameter Description
DNS name of the RADIUS security
hostname
server host.
IP address of the RADIUS security
ip-address
server host.
UDP
auth-port
authentication.
Number of the UDP port used for
RADIUS authentication. If it is set to 0,
port-number
this
authentication.
acct-port UDP port used for RADIUS accounting.
DES-7200 CLI Reference Guide
port used for
host does not
RADIUS
perform