Ip Rip Authentication Key-Chain - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Related
commands
Platform
description
Version
description
31.1.9

ip rip authentication key-chain

Use this ocmmand to enable the RIP authentication and specify the keychain used for RIP
authentication in the interface configuration mode. The no form of this command is used to
delete the specified keychain.
ip rip authentication key-chain name-of-keychain
no ip rip authentication key-chain
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
DES-7210(config-router-af)# exit-address-family
Parameter Description
Enter
address-family
sub-mode
Parameter
name-of-keychain
RIP authentication is disabled by default.
Interface configuration mode.
If the keychain is specified in the interface configuration mode but not
defined with the key chain global configuration command, the RIP
authentication will not occur.
The RIPv1 does not support authentication but the RIPv2 does.
The configuration example below enables the RIP authentication on
interface serial 0 with the associated keychain is ripchain.
DES-7210 (config)#interface serial 0/0
DES-7210 (config-if)#ip rip authentication key-chain ripchain
Chapter 31 RIP Configuration Commands
the address family
Description
Name of the keychain used for RIP
authentication
configuration
31-11