Table of Contents
Advertisement
4 Web-based Switch Configuration
Firmware Backup and Upgrade
Allow for the firmware to be saved, or for an existing firmware file to be uploaded to the Switch. Two methods
can be selected: HTTP or TFTP.
HTTP: Backup or upgrade the firmware to or from your local PC drive.
Backup firmware to file: Select image_id 1 or image_id 2.
Click Backup to save the firmware to your disk.
Click Choose File to browse your inventories for a saved firmware file.
Click Upgrade after selecting the firmware file you want to restore.
TFTP: Specifies the Image_id 1 or Image_id 2 to backup or upgrade the firmware to or from a remote TFTP
server. Specifies TFTP Server IP Address with IPv4 or IPv6 address and TFTP File Name for the
configuration file you want to save to / restore from.
Backup firmware to file: Select Image_id1 or Image_id 2.
Click Backup to save the firmware to the TFTP server.
Click Upgrade after selecting the firmware file you want to restore.
Firmware Information
This page displays the firmware information and allow user to identify the image used for system boot.
Configuration Information
This page displays the configuration information and allow user to identify the config used for system boot.
Figure 4.10 – Tool Menu > Firmware Backup and Upload
NOTE: Do not disconnect the PC or remove the
power cord from device until the upgrade
completes. The Switch may crash if the
Firmware upgrade is incomplete.
Figure 4.11 – Tool Menu > Firmware Information
Figure 4.12 – Tool Menu > Configuration Information
2
2
D-Link DGS-2000 Series Ethernet Switch User Manual
8
8
Advertisement
Table of Contents
