DES-7200 CLI Reference Guide
Command
mode
Usage
guidelines
Examples
Related
commands
36.1.16 ipv6 nd managed-config-flag
Use this command to set the ―managed address configuration‖ flag of the RA message. Use
the no form of this command to remove the setting.
ipv6 nd managed-config-flag
no ipv6 managed-config-flag
Default
configuration
Command
mode
Usage
guidelines
Examples
Interface configuration mode.
If it is specified as 0, the RA will not have the MTU option.
DES-7210(config)# interface vlan 1
DES-7210(config -if)# ipv6 nd ra-mtu 1400
Command
Description
show ipv6
Show the interface information.
interface
ipv6 nd
Set the lifetime of the device.
ra-lifetime
ipv6 nd
Set the interval of sending the RA message.
ra-interval
ipv6 nd
Set the hopcount of the RA message.
ra-hoplimit
None.
Interface configuration mode.
This flag determines whether the host that receives the RA message
obtains an IP address through stateful auto configuration. If the flag is
set, the host obtains an IP address through stateful auto
configuration, otherwise it does not be used.
DES-7210(config)# int vlan 1
DES-7210(config)# ipv6 nd managed-config-flag
Chapter 36 IPv6 Configuration Commands
36-15