Address-Family Vpnv4 - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
commands
42.2.2

address-family vpnv4

Use this command to enter to or exit from the vpn address family mode and enables VPN
information interaction between the PEs.
[no] address-family vpnv4 [unicast]
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
neighbor activate
exit-address-family
Parameter
unicast
By default, no vpn address family is defined.
Router mode
Use this command to enable the VPN routing information interaction
between PEs and enter the address-family VPN mode. Use
command exit-address-family to exit from the address-family VPN
configuration mode.
DES-7210(config)# router bgp 100
DES-7210 (config-router)# address-family vpnv4
Command
neighbor activate
Chapter 42 MPLS Configuration Commands
Activate an address family
Exit from this mode.
Description
Specify the unicast address prefix
Description
Activate an address family
42-43