Neighbor Password - D-Link DES-7200 Cli Reference Manual

Chapter 33 BGP4 Configuration Commands
no neighbor {peer-address | peer-group-name} next-hop-self
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
Platform
description

33.1.51 neighbor password

When the BGP connection with the BGP peer is established, use this command to enable
the TCP MD5 authentication and set the password. The no form of the command disables
MD5 authentication.
neighbor {peer-address | peer-group-name} password [0 | 7 ]string
no neighbor {peer-address | peer-group-name} password
33-48
Parameter Description
peer-address IP address of the peer, IPv4 or IPv6 address
peer-group-name Name of the peer group of up to 32 characters
Disabled.
BGP configuration mode, address-family IPv4 configuration mode,
address-family IPv6 configuration mode, address-family IPv4 VRF
configuration mode.
This command is mostly used in the non-full-mesh-type network,
such as the Frame Relay and X.25, where the BGP speakers within
the same subnet cannot completely be accessed mutually.
If you have specified the BGP peer group, all members of the peer
group will inherit the settings of the command.
DES-7210(config)# router bgp 65000
DES-7210(config-router)# neighbor 10.0.0.1 next-hop-self
Command Description
Enable the BGP protocol.
router bgp
neighbor
Configure the BGP peer.
remote-as
DES-7200 CLI Reference Guide