Advertisement
IEC 60601-1-2:2001:
Table 204 – Guidance and Manufacturer's Declaration – Electromagnetic
Immunity – For Equipment and System that are Not Life-Supporting
The A
Component Collection System is intended for use in the electromagnetic environment specified
LYX
below. The user of the A
environment.
Immunity Test
IEC 60601
Test Level
Conducted RF
3 Vrms
150 kHz to 80 mHz
IEC 61000-4-6
Radiated RF
3 V/m
80 MHz to 2.5 GHz
IEC 61000-4-3
Note 1: At 80 MHz and 800 MHz, the higher frequency applies.
Note 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects, and people.
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile
a
radios, amateur radio, AM and FM radio broadcast, and TV broadcast cannot be predicted theoretically with accuracy.
To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be
considered. If the measured field strength in the location in which the
exceeds the applicable RF compliance level above, the
verify normal operation. If abnormal performance is observed, additional measures may be necessary, such as re-
orienting or relocating the
Over the frequency range 150 kHz to 80 MHzk, field strengths should be less than 3 V/M.
b
07-19-01-518 – January 2009
A
C
LYX
OMPONENT
Component Collection System should assure that it is used in such an
LYX
Complianc
e Level
3 Vrms
3 V/m
A
LYX Component Collection System
C
S
OLLECTION
C
HAPTER
Electromagnetic Environment Guidance
Portable and mobile RF communications equipment should be
used no closer to any part of the
System, including cables, than the recommended separation
distance calculated from the equation applicable to the
frequency of the transmitter.
Recommended separation distance:
d = [3.5/3]√P
d = [3.5/3]√P 80 MHz to 800 MHz
d = [7/3]√P 800 MHz to 2.5 GHz
where P is the maximum output power rating of the transmitter
in watts (W) according to the transmitter manufacturer and d is
the recommended separation distance in meters (m).
Field strengths from fix RF transmitters, as determined by an
electromagnetic survey
should be less than the compliance
a
level in each frequency range.
Interference may occur in the vicinity of equipment
marked with the symbol shown here.
A
LYX Component Collection System is used
A
LYX Component Collection System should be observed to
O
'
M
YSTEM
PERATOR
S
7 – S
S
YSTEM
PECIFICATIONS
A
LYX Component Collection
b
ANUAL
7-11
Advertisement
