Advertisement
Umbilicus
Guides
07-19-01-518 – January 2009
A
C
LYX
OMPONENT
C
HAPTER
The following steps (13 through 16) are used with a 3-Arm
centrifuge carrier configuration that locks the separation chamber
into position after the chamber is inserted into the carrier arms
and pulled up to engage the latch. To remove or reseat the
chamber, press on the latch and pull the chamber down. A green
indicator on the latch informs the operator when the chamber
has been properly loaded or if the chamber is completely
unloaded. The red indicator informs the operator when the
chamber is improperly loaded.
13. Rotate the centrifuge carrier so that the two umbilicus guides
are on the left and align the carrier latch with the opening in
the carrier mount.
Alignment of Carrier Latch
14. Slide the separation chamber into the carrier arms at a slight
angle with the front in a lower position than the back.
Placing the Separation Chamber into Carrier
C
S
OLLECTION
YSTEM
4C – A
2RBC-NLR C
LYX
Carrier Latch
O
'
M
PERATOR
S
ANUAL
P
OLLECTION
ROCEDURE
3-Arm
Carrier
4C-15
Advertisement
