Advertisement
Network
Settings Button
Enable
Administrator
Mode Button
07-19-01-518 – January 2009
A
C
LYX
OMPONENT
Viewing Network and System Information
Various aspects of system information may be viewed using the
touch screen. The information can be broken down into the
following categories:
•
Network Settings
o IP Address
o Subnet Mask
•
System Information
o Procedure Summary
o Time In Use
o Component Usage
o Software Version
o Alarm Histogram and Summary
Network Settings. Network settings provide information
about the configuration of the instrument if it were to be
connected to a computer, network, or server. Touching the
network settings button provides the IP address and subnet mask
for the specific settings used to program the instrument to be
accessible via an Ethernet connection to a computer system.
For additional information refer to the Administrator's Guide.
In general, network settings should not be changed without the
assistance of technical personnel trained to use computer
systems. If you have any questions regarding networking your
instrument with the use of an Ethernet connection, consult
your service representative.
Note: If the enable administrator mode button is touched, and entry
into this mode is confirmed, the instrument must be power
cycled to exit.
Note: Network settings and system information buttons are
not available if a procedure or kit code have been entered.
C
S
O
OLLECTION
YSTEM
C
3 – O
HAPTER
PERATING CONSIDERATIONS
'
M
PERATOR
S
ANUAL
3-55
Advertisement
