Chapter 1 Introduction - Delta C2000 Series User Manual

1-1 Receiving and Inspection
After receiving the AC motor drive, please check for the following:
1. Please inspect the unit after unpacking to assure it was not damaged during shipment. Make sure that
the part number printed on the package corresponds with the part number indicated on the
nameplate.
2. Make sure that the voltage for the wiring lie within the range as indicated on the nameplate. Please
install the AC motor drive according to this manual.
3. Before applying the power, please make sure that all the devices, including power, motor, control
board and digital keypad, are connected correctly.
4. When wiring the AC motor drive, please make sure that the wiring of input terminals "R/L1, S/L2, T/L3"
and output terminals"U/T1, V/T2, W/T3" are correct to prevent drive damage.
5. When power is applied, select the language and set parameter groups via the digital keypad
(KPC-CC01). When executes trial run, please begin with a low speed and then gradually increases
the speed untill the desired speed is reached.
1-2 Nameplate Information
AC Driv e Model
Input Volt age/Current
Output Voltage/Current
Frequency Range
Firmware Version
Enclosure type (IPXX)
Cert ifications
Serial Number

Chapter 1 Introduction

MODE L:VFD0 07 C43 A
INPUT:
Nor mal D uty: 3 PH 3 80 -4 80 V 5 0/6 0Hz 4 .3A
Hea vy D uty: 3 PH 3 80 -4 80 V 5 0/6 0Hz 4 .1A
OUTPUT:
Nor mal D uty: 3 PH 0 -4 80 V 3 A 2 .4 KVA 1 HP
Hea vy D uty: 3 PH 0 -4 80 V 2 .9A 2 .3K VA 1 HP
FREQUENCY RANGE:
Normal Duty: 0-600Hz
Heavy Dut y: 0-300Hz
Ver si on:
VX.XX
007C43A7T14300002
DELTA ELECTRONICS. INC.
MADE IN XXXXXXX
1-1
Chapter 1 Introduction C2000 Series