Delta C2000 Series User Manual page 291

Settings Functions
25 REV JOG command
FOCPG/TQCPG mode
26
selection
27 ASR1/ASR2 selection
Emergency stop (EF1)
28
Signal confirmation for
29
Y-connection
Signal confirmation for
30
-connection
31 High torque bias
32 Middle torque bias
Low torque bias
33
Chapter 12 Description of Parameter Settings C2000 Series
This function is valid when the source of operation command is
external terminals.
When the contact of this function is ON the drive will execute
reverse Jog command.
When execute JOG command under torque mode, the drive will
automatically switch to speed mode; after JOG command is done,
the drive will return to torque mode.
When the contact of this function is ON: TQCPG mode.
When the contact of this function is OFF: FOCPG mode.
RU N/ STOP
com mand
Mu lti-fun ct ion inpu t
te rm inal is set to 2 6
OFF
(t orque /spee d
m ode swit ch)
s peed
03-00 ~02 =1
com mand
(AVI /AU I/AC I is
fr eq uen cy comma nd)
torque
l i mit
03-00 ~0 2=2
(AVI /AUI /AC I is
torqu e co mman d)
s peed
C ont ro l c ontrol
mo de
S witc h tim ing for torque/speed c ontr ol
(00-10=0/4, m ulti-function input ter minal is s et t o 26)
When the contact of this function is ON: speed will be adjusted by
ASR 2 setting. OFF: speed will be adjusted by ASR 1 setting. Refer
to Pr.11-02 for details.
When the contact is ON, the drive will execute emergency stop and
display EF1 on the keypad. The motor won't run and be in the free
run until the fault is cleared after pressing RESET" (EF: External
Fault)
When is the contact of this function is ON, the drive will operate by
1st V/f.
When the contact of this function is ON, the drive will operate by
2nd V/f.
Refer to Pr.11-30~11-32 for details.
12-02-6
Descriptions
RUN
ON OFF
speed li mit s peed speed li mit
com mand
t orque
t orque l imi t
c ommand comm and
s peed
t orque
tor que
c ontrol
c ontrol
c ont rol
STOP
ON
torque
s peed
c ontrol
(dec el. t o stop)