Delta C2000 Series User Manual page 290

Settings Functions
Output Stop
12
(Output pause)
Cancel the setting of the
13
optimal accel./decel. time
Switch between drive
14
settings 1 and 2
Operation speed
15
command form AVI
Operation speed
16
command form ACI
Operation speed
17
command form AUI
18 Emergency Stop (07-20)
19 Digital Up command
20 Digital Down command
21 PID function disabled
22 Clear counter
Input the counter value
23 (multi-function input
command 6)
24 FWD JOG command
Chapter 12 Description of Parameter Settings C2000 Series
If the contact of this function is ON, output of the drive will be cut off
immediately, and the motor will then be free run. And once it is
turned to OFF, the drive will accelerate to the setting frequency.
Before using this function, Pr.01-44 should be set to 01/02/03/04
first. When this function is enabled, OFF is for auto mode and ON is
for linear accel./decel.
When the contact of this function is ON: use motor 2 parameters.
OFF: use motor 1 parameters.
When the contact of this function is ON, the source of the frequency
will force to be AVI. (If the operation speed commands are set to
AVI, ACI and AUI at the same time. The priority is AVI ACI AUI)
When the contact of this function is ON, the source of the frequency
will force to be ACI. (If the operation speed commands are set to
AVI, ACI and AUI at the same time. The priority is AVI ACI AUI)
When the contact of this function is ON, the source of the frequency
will force to be AUI. (If the operation speed commands are set to
AVI, ACI and AUI at the same time. The priority is AVI ACI AUI)
When the contact of this function is ON, the drive will ramp to stop
by Pr.07-20 setting.
When the contact of this function is ON, the frequency will be
increased and decreased. If this function is constantly ON, the
frequency will be increased/decreased by Pr.02-09/Pr.02-10.
The frequency command returns to zero when the drive stops, and the
display frequency is 0.00Hz. Select Pr11-00, Bit7=1, frequency is not
saved.
When the contact of this function is ON, the PID function is
disabled.
When the contact of this function is ON, it will clear current counter
value and display "0". Only when this function is disabled, it will
keep counting upward.
The counter value will increase 1 once the contact of this function is
ON. It needs to be used with Pr.02-19.
This function is valid when the source of operation command is
external terminals.
When the contact of this function is ON, the drive will execute
forward Jog command.
When execute JOG command under torque mode, the drive will
automatically switch to speed mode; after JOG command is done,
the drive will return to torque mode.
12-02-5
Descriptions