Delta C2000 Series User Manual page 380

5. Set Pr.06=56=1.37 and Pr.06-58=10Hz. When RTD temperature increases to 135
the drive will decelerate to the selected frequency. When Pr.06-58=0, the drive will not run.
6. Set Pr.06-57=1.42 and Pr.06-29=1 (warning and decelerate to stop). When RTD temperature
increases to 150
Software Detection GFF Current Level
Settings 0.0~6553.5 %
Software Detection GFF Filter Time
Settings 0.00~655.35 sec
When the motor drive detects the unbalanced three-phase out current is higher than the setting of
Pr06-60, GFF protection will be activated. Then the motor drive will stop outputting.
When 3-phase current output unbalance value has exceeds Pr06-60 setting, drive will trip up GFF
and stop output immediately.
Reserved
Fault Record 1 (day)
Fault Record 2 (day)
Fault Record 3 (day)
Fault Record 4 (day)
Settings 0~65535 days
Fault Record 1 (min)
Fault Record 2 (min)
Fault Record 3 (min)
Fault Record 4 (min)
Settings 0~1439 min
When there is any malfunctions in motor drive operation, Pr06-17~22 will record 6 malfunctions
recently, and Pr06-63~70 can record the operation time for 4 malfunctions in sequence. It can help
to check if there is any wrong with the drive according to the recorded internal time.
For example: The first error: ocA occurs in 1000 minutes after motor drive start operation. The
second error: ocd happens after another 1000 minutes. The 4
1000 minutes. Then, the 5
ocn happens 1000 minutes after 5
Then Pr06-17~Pr06-22 and Pr06-63~Pr06-70 will be:
Chapter 12 Description of Parameter Settings C2000 Series
or higher, the drive will decelerate to stop and outputs an 'OH3' warning.
th
error is ocd, happening 1000 minutes following 4
th
error.
12-06-27
Factory Setting: 60.0
Factory Setting: 0.10
Factory Setting: Read only
Factory Setting: Read only
th
error: ocA happens after another
th
error. Last, 6
or higher,
th
error