Delta C2000 Series User Manual page 303

Settings Functions
51 Output for RS-485
Output for
52
communication card
53~64 Reserved
Output for CANopen and
65
RS485
66 SO contact A (N.O.)
68 SO contact B (N.C.)
Analog input signal level
67
achieved
Chapter 12 Description of Parameter Settings C2000 Series
For RS485 output.
For communication output of communication cards
(CMC-MOD01, CMC-EIP01, CMC-PN01 and CMC-DN01)
Setting of
Physical
related
terminal
parameters
RY1 P2-13 = 51
RY2 P2-14 = 51
P2-15 = 51
MO1 P2-16 = 51
MO2 P2-17 = 51
MO3 P2-18 = 51
MO4 P2-19 = 51
MO5 P2-20 = 51
MO6 P2-21 = 51
MO7 P2-22 = 51
MO8 P2-23 = 51
To be control output of CANopen & RS485.
Status of drive
Normal
STO
STL1~STL3
Multi-function output terminals operate when analog input signal
level is between high level and low level.
03-44: Select the analog signal channel, AVI, ACI, and AUI which
is going to be compared.
03-45: The high level of analog input, factory setting is 50%.
03-46: The low level of analog input, factory setting is 10%.
If analog input > 03-45, then multi-function output terminal
operates.
If analog input < 03-46, then multi-function output terminal stops
outputting.
12-02-18
Descriptions
Attribute
RW The Bit 0 of 2640
RW The Bit 1 of 2640
RW The Bit 2 of 2640
RW The Bit 3 of 2640
RW The Bit 4 of 2640
RW The Bit 5 of 2640
RW The Bit 6 of 2640
RW The Bit 7 of 2640
RW The Bit 8 of 2640
RW The Bit 9 of 2640
RW The Bit 10 of 2640
Status of safety output
N.O. (MO=66)
Broken circuit
(Open)
Short circuit
(Close)
Short circuit
(Close)
Corresponding
Address
N.C. (MO=68)
Short circuit
(Close)
Broken circuit
(Open)
Broken circuit
(Open)