Delta C2000 Series User Manual page 156

Environment
Noise immunity
Operation/storage
Vibration/shock immunity
Install CMC-MOD01 to VFD-C2000
1. Switch off the power supply of VFD-C2000.
2. Open the front cover of VFD-C2000.
3. Place the insulation spacer into the positioning pin at Slot 1 (shown in Figure 3), and aim the
two holes on the PCB at the positioning pin. Press the pin to clip the holes with the PCB (shown
in Figure 4).
4. Screw up at torque 6 ~ 8 kg-cm (5.21 ~ 6.94 in-lbs) after the PCB is clipped with the holes
(shown in Figure 5).
Communication Parameters for VFD-C2000 Connected to Ethernet
When VFD-C2000 is link to Ethernet, please set up the communication parameters base on the
table below. Ethernet master will be able to read/write the frequency word and control word of
VFD-C2000 after communication parameters setup.
Parameter
Source of frequency
P00-20
command setting
Source of operation
P00-21
command setting
ESD (IEC 61800-5-1, IEC 61000-4-2)
EFT (IEC 61800-5-1, IEC 61000-4-4)
Surge Test (IEC 61800-5-1, IEC 61000-4-5)
Conducted Susceptibility Test (IEC 61800-5-1, IEC 61000-4-6)
Operation: -10°C ~ 50°C (temperature), 90% (humidity)
Storage: -25°C ~ 70°C (temperature), 95% (humidity)
International standard: IEC 61800-5-1, IEC 60068-2-6/IEC
61800-5-1, IEC 60068-2-27
Slot 3
Slot 2 Slot 1
[Figure 3]
[Figure 5]
Function Set value (Dec)
Chapter 8 Optional Cards
The frequency command is controlled by
8
communication card.
The operation command is controlled by
5
communication card.
8-23
C2000 Series
[Figure 4]
Explanation