Delta C2000 Series User Manual page 42

Chapter 3 Unpacking C2000 Series
Frame H
Crate 3 (VFDXXXC43E)
Use flathead screwdriver to remove the clips on the side of the crate, 8 clips in total.
Secure the drive from the external. (Skip to the
next step if this situation does not apply to you.)
Loosen 8 of M8 screws on the both sides and place
the 2 plates that were removed from the last step.
Fix the plates to AC motor drive by fasten 8 of the
M8 screws. (As shown in below)
Torque: 150~180kg-cm (130.20~156.24lb-in.)
Lift the drive by hooking the lifting hole. It is now
ready for installation.
3-8