Delta C2000 Series User Manual page 281

JOG Frequency
Settings 0.00~600.00Hz
Both external terminal JOG and key "F1" on the keypad KPC-CC01 can be used. When the jog
command is ON, the AC motor drive will accelerate from 0Hz to jog frequency (Pr.01-22). When the
jog command is OFF, the AC motor drive will decelerate from Jog Frequency to zero. The Jog
Accel./Decel. time (Pr.01-20, Pr.01-21) is the time that accelerates from 0.0Hz to Pr.01-22 JOG
Frequency.
The JOG command can't be executed when the AC motor drive is running. In the same way, when
the JOG command is executing, other operation commands are invalid.
It does not support JOG function in the optional keypad KPC-CE01.
1st/4th Accel./decel. Frequency
Settings 0.00~600.00Hz
The transition from acceleration/deceleration time 1 to acceleration/deceleration time 4, may also be
enabled by the external terminals. The external terminal has priority over Pr. 01-23.
When using this function, please set S-curve acceleration time as 0 if 4
short.
Freq uen cy
01-23
S-curve Acceleration Begin Time 1
S-curve Acceleration Arrival Time 2
S-curve Deceleration Begin Time 1
S-curve Deceleration Arrival Time 2
Settings Pr.01-45=0: 0.00~25.00 seconds
Pr.01-45=1: 0.00~250.0 seconds
It is used to give the smoothest transition between speed changes. The accel./decel. curve can
adjust the S-curve of the accel./decel. When it is enabled, the drive will have different accel./decel.
curve by the accel./decel. time.
The S-curve function is disabled when accel./decel. time is set to 0.
Chapter 12 Description of Parameter Settings C2000 Series
1s t Accel eration
Ti me
4th Ac celerat ion
Time
1st/4th Ac celeration/Decel er ation F r equenc y Switching
12-01-8
Factory Setting: 6.00
Factory Setting: 0.00
th
1st D eceleration
Time
4th D eceleration
Time
Factory Setting: 0.20/0.2
acceleration time is set too
T ime