Delta C2000 Series User Manual page 367

Fault Code
108~110: Reserved
111: InrCOM Internal communication overtime
error
112: PM sensorless shaft Lock error
113: Software OC
PTC (Positive Temperature Coefficient) Detection Selection
Settings
Pr.06-29 setting defines how the will drive operate after PTC detection.
PTC Level
Settings
It needs to set AVI/ACI/AUI analog input function Pr.03-00~03-02 to 6 (P.T.C. thermistor input
value).
It is used to set the PTC level, and the corresponding value for 100% is max. analog input value.
Frequency Command for Malfunction
Settings
When malfunction occurs, use can check the frequency command. If it happens again, it will
overwrite the previous record.
Output Frequency at Malfunction
Settings
When malfunction occurs, use can check the current frequency command. If it happens
again, it will overwrite the previous record.
Output Voltage at Malfunction
Settings
When malfunction occurs, user can check current output voltage. If it happens again, it will
overwrite the previous record.
DC Voltage at Malfunction
Settings
When malfunction occurs, user can check the current DC voltage. If it happens again, it will
overwrite the previous record.
0: Warn and keep operating
1: Warn and ramp to stop
2: Warn and coast to stop
3: No warning
0.0~100.0%
0.00~655.35Hz
0.00~655.35Hz
0.0~6553.5V
0.0~6553.5V
12-06-14
Chapter 12 Description of Parameter Settings C2000 Series
Bit0 Bit1 Bit2
current Volt. OL
Bit3 Bit4 Bit5
SYS FBK EXI
Factory Setting: 0
Factory Setting: 50.0
Factory Setting: Read only
Factory Setting: Read only
Factory Setting: Read only
Factory Setting: Read only
Bit6
CE