Pots Flash Commands - ZyXEL Communications MSC1000G User Manual

36.9 pots flash Commands

Syntax:
voip pots flash set DEFVAL|{<min> <max>}
voip pots flash show
where
<min>
<max>
Use these commands to set and display how long (in milliseconds) a user has to press the flash key
for the IES to register its use. DEFVAL uses the period defined in the country code setting.
The following example sets the IES to recognize a flash key press of 0.1 to 1.5 seconds.
ras> voip pots flash set 100 1500
36.9.1 voip pots flash show Command
Syntax:
voip pots flash show
This command shows the POTS flash settings.
36.10 pots ring Commands
Use these commands to name and configure POTS (Plain Old Telephony Service) distinctive ring
patterns. These ring patterns define the ring the VOP sends to the connected POTS phones for
incoming calls. You define the ring patterns here. The SIP server defines which ring pattern to use.
36.10.1 voip pots ring name Command
Syntax:
voip pots ring name <index> DEFVAL|<name>
Use this command to set the name of the specified POTS ring pattern. DEFVAL has the ring pattern
use the default name according to the country code setting.
The following example sets the name of the first ring pattern to Test.
ras> voip pots ring name 1 Test
Management Switch Card User's Guide
= Specify a minimum number of milliseconds that the flash key has to be pressed. You
can use 20~1500.
Note: Setting the minimum to less than 80 ms disables flash key pulse detection.
=
Specify a maximum number of milliseconds for the flash key to be pressed. The valid
range is from the number specified as the minimum to 1500.
Chapter 36 voip Commands
1081