Voip H248 Interface Show Command - ZyXEL Communications MSC1000G User Manual

36.4.7 voip h248 interface show command

Syntax:
voip h248 interface show [<id>]
Use this command to see H.248 interface settings. Specify an interface's ID to see details about
that interface.
The following example shows H.248 interface 1's settings.
ras> voip h248 interface show 1
id
ip/mask
vid
primary slot
secondary slot : 6
mg name
h248 profile
mg port
mg state
bhca peak
bhca average
36.4.8 voip h248 interface slave command
Syntax:
voip h248 interface slave <id> <member> <ip-address> [<step>]
where
member
step
Use this command to specify an H.248 interface's media cards.
The following example sets H.248 interface 1 to use a VOP card in slot 1 with IP address
192.168.3.174 as a media (slave) card.
ras> voip h248 interface slave 1 1 192.168.3.174
36.4.9 voip h248 master command
Syntax:
voip h248 master <slot> <ip-address 1> <ip-address 2>
Management Switch Card User's Guide
: 1
: 172.23.19.200/24
: 1
: 3
: MG1
: MEGACO
: 2944
: enable
: 20 calls/second
: 10000 calls/hour
The number of the media (slave) card in the H.248 interface (1~27). You can also
specify a range to add multiple cards.
When adding multiple cards, enter the interval between IP addresses.
For example, enter "1~10" for the member and "1" for the step to increment each
media card's IP address by one.
Chapter 36 voip Commands
1075