Show Power-Inline Interface Detail - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

P E C
OWER OVER THERNET OMMANDS
-
SHOW POWER INLINE INTERFACE DETAIL

show power-inline interface detail

Overview This command displays detailed information for one or more Power over Ethernet
(PoE) ports.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
Syntax show power-inline interface [<port-list>] detail
Mode User Exec and Privileged Exec
Usage The power allocated to each port is listed in the Power allocated row, and is
limited by the maximum power per Powered Device (PD) class, or a user
configured power limit.
Examples To display detailed PoE port specific information for the port range 1.0.1 to 1.0.3,
use the command:
awplus#
Output Figure 16-5: Example output from the show power-inline interface detail
613-50157-01 Rev C
Parameter Description
<port-list>
Enter the PoE port(s) to display information about only the specified
port or ports.
show power-inline interface port1.0.1-1.0.3 detail
command
awplus#show power-inline interface port1.0.1-1.0.2 detail
Interface port1.0.1
Powered device type: Desk Phone #1
PoE admin enabled
Priority Low
Detection status: Powered
Current power consumption: 4800 mW
Powered device class: 1
Power allocated: 5000 mW (from configuration)
Detection of legacy devices is disabled
Powered pairs: Data
Interface port1.0.2
Powered device type: Access Point #3
PoE admin enabled
Priority High
Detection status: Powered
Current power consumption: 6720 mW
Powered device class: 2
Power allocated: 7000 mW (from powered device class)
Detection of legacy devices is enabled
Powered pairs: Data
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
"Getting Started
Guide.
567