Speed - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

S C
WITCHING OMMANDS

SPEED

speed
Overview This command changes the speed of the specified port. You can optionally specify
the speed or speeds that get autonegotiated, so autonegotiation is only
attempted at the specified speeds.
To see the currently-negotiated speed for ports whose links are up, use the
interface
default), use the
speed {10|100|1000}
Syntax
speed auto [10] [100] [1000]
The following table shows the speed options for each type of port.
Mode Interface Configuration
Default By default, ports autonegotiate speed.
Usage Switch ports in a static or dynamic (LACP) channel group must have the same port
speed and be in full duplex mode. Once switch ports have been aggregated into a
channel group, you can set the speed of all the switch ports in the channel group
by applying this command to the channel group.
NOTE
then the device only attempts autonegotiation at those specified speeds.
Examples To set an SFP to a fixed speed of 1000Mbps, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To return the port to auto-negotiating its speed, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
613-50157-01 Rev C
command. To see the configured speed (when different from the
show running-config
Port type
RJ-45 copper ports
100Mbps fiber SFPs
1000Mbps fiber SFPs
: If multiple speeds are specified after the auto option to autonegotiate speeds,
configure terminal
interface port1.0.49
configure terminal
interface port1.0.49
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
command.
Speed Options (units are Mbps)
auto (default)
10
100
100
auto (default)
1000
speed 1000
speed auto
show
397