Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 882

Q S C
O OMMANDS
-
REMARK NEW COS
Figure 27-1: Remarking and the CoS to Q map
Table 27-1: CoS to egress queue remarking function
Example For policy-map "pmap3" and class-map "cmap1", set the CoS value to 2 and also set
the input to the CoS to queue map so that the traffic is assigned to egress queue 1:
awplus#
awplus(config)#
awplus(config-pmap)#
awplus(config-pmap-c)#
Related mls qos map cos-queue to
Commands
show mls qos maps cos-queue
613-50157-01 Rev C
Input Command
CoS field = 1 Remark new-cos (not
configured)
CoS field = 1 Remark new-cos 2 external
CoS set to 1 Remark new-cos 2 internal
CoS set to 1 Remark new-cos 2 both
Note: This table assumes that the CoS to Queue map is set to its default values.
configure terminal
policy-map pmap3
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
class cmap1
remark new-cos 2 both
Output
CoS value = 1
Packet sent to egress queue 0
CoS value = 2
Packet sent to egress queue 0
CoS value = 1
Packet sent to egress queue 1
CoS value = 2
Packet sent to egress queue 1
882