Auth Supplicant-Mac - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

A C
UTHENTICATION OMMANDS
-
AUTH SUPPLICANT MAC

auth supplicant-mac

Overview This command adds a supplicant (client device) MAC address or MAC mask on a
given interface with the parameters as specified in the table below.
Use the no variant of this command to delete the supplicant MAC address and
reset other parameters to their default values.
Syntax auth supplicant-mac <mac-addr> [mask <mac-addr-mask>]
[max-reauth-req <1-10>] [port-control
{auto|force-authorized|force-unauthorized|skip-second-auth}]
[quiet-period <1-65535>] [reauth-period <1-4294967295>]
[supp-timeout <1-65535>] [server-timeout <1-65535>]
[reauthentication]
no auth supplicant-mac <mac-addr> [reauthentication]
613-50157-01 Rev C
Parameter
<mac-addr>
mask
<mac-addr-mask>
port-control
auto
force-authorized
force-unauthorized Force port state to unauthorized.
skip-second-auth
quiet-period
<1-65535>
reauth-period
<1-4294967295>
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Description
MAC (hardware) address of the supplicant entry in
HHHH.HHHH.HHHH MAC address hexadecimal format.
A mask applied to MAC addresses in order to select only
those addresses containing a specific string.
The mask comprises a string of three (period separated)
bytes, where each byte comprises four hexadecimal
characters that will generally be either 1or 0. When the
mask is applied to a specific MAC address, a match is only
required for characters that correspond to a 1 in the mask.
Characters that correspond to a 0 in the mask are
effectively ignored.
In the examples section below, the mask ffff.ff00.0000 is
applied for the MAC address 0000.5E00.0000. The applied
mask will then match only those MAC addresses that begin
with 0000.5E (in this case the OUI component). The
remaining portion of the addresses (in this case the NIC
component) will be ignored.
Port control commands.
Allow port client to negotiate authentication.
Force port state to authorized.
Skip the second authentication.
Quiet period in the HELD state (default 60 seconds).
Seconds for quiet period.
Seconds between reauthorization attempts (default 3600
seconds).
Seconds for reauthorization attempts (reauth-period).
972