Spanning-Tree Mst Instance Priority - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

S T C
PANNING REE OMMANDS
-
SPANNING TREE MST INSTANCE PRIORITY

spanning-tree mst instance priority

Overview Use this command in Interface Configuration mode for a switch port interface only
to set the port priority for an MST instance (MSTI).
Use the no variant of this command to restore the default priority value (128).
Syntax spanning-tree mst instance <instance-id> priority <priority>
no spanning-tree mst instance <instance-id> [priority]
Default The default is 128.
Mode Interface Configuration mode for a switch port interface.
Usage This command sets the value of the priority field contained in the port identifier.
The MST algorithm uses the port priority when determining the root port for the
switch in the MSTI. The port with the lowest value has the highest priority, so it will
be chosen as root port over a port that is equivalent in all other aspects but with a
higher priority value.
Examples To set the priority to 112 on instance 3, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To return the priority to its default value of 128 on instance 3, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related instance vlan (MSTP)
Commands
spanning-tree priority (port priority)
spanning-tree mst instance
spanning-tree mst instance path-cost
spanning-tree mst instance restricted-role
spanning-tree mst instance restricted-tcn
613-50157-01 Rev C
Parameter Description
<instance-id>
Specify an MSTP instance in the range 1-5.
<priority>
This must be a multiple of 16 and within the range <0-240>. A
lower priority indicates greater likelihood of the port becoming
the root port.
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
spanning-tree mst instance 3 priority 112
no spanning-tree mst instance 3 priority
505