Vlan Classifier Rule Proto - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

VLAN C
OMMANDS

VLAN CLASSIFIER RULE PROTO

vlan classifier rule proto
Overview Use this command to create a protocol type-based VLAN classifier rule, and map it
to a specific VLAN. See the published IANA EtherType IEEE 802 numbers here:
www.iana.org/assignments/ieee-802-numbers/ieee-802-numbers.txt.
Instead of a protocol name the decimal value of the protocol's EtherType can be
entered. The EtherType field is a two-octet field in an Ethernet frame. It is used to
show which protocol is encapsulated in the payload of the Ethernet frame. Note
that EtherTypes in the IANA 802 numbers are given as hexadecimal values.
The no variant of this command removes a previously set rule.
Syntax vlan classifier rule <1-256> proto <protocol> encap
{ethv2|nosnapllc|snapllc} vlan <1-4094>
no vlan classifier rule <1-256>
613-50157-01 Rev C
Parameter Description
<1-256>
VLAN Classifier identifier
proto
Protocol type
<protocol>
Specify a protocol either by its decimal number (0-65535) or by one
of the following protocol names:
[arp|2054]
[atalkaarp|33011]
[atalkddp|32923]
[atmmulti|34892]
[atmtransport|34948]
[dec|24576]
[deccustom|24582]
[decdiagnostics|24581]
[decdnadumpload|24577]
[decdnaremoteconsole|24578] DEC DNA Remote
[decdnarouting|24579]
[declat|24580]
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Address Resolution
protocol
Appletalk AARP protocol
Appletalk DDP protocol
MultiProtocol Over ATM
protocol
Frame-based ATM
Transport protocol
DEC Assigned protocol
DEC Customer use
protocol
DEC Systems Comms
Arch protocol
DEC DNA Dump/Load
protocol
Console protocol
DEC DNA Routing
protocol
DEC LAT protocol
440