Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 796

IP 4 H A C
V ARDWARE CCESS ONTROL
( ACL: TCP
NAMED HARDWARE OR
Mode IPv4 Hardware ACL Configuration (accessed by running the command
hardware (named hardware
Default On an interface controlled by a hardware ACL, any traffic that does not explicitly
match a filter is permitted.
Usage To use this command, first run the command
hardware ACL)
awplus(config-ip-hw-acl)#.
613-50157-01 Rev C
L (ACL) C
IST OMMANDS
UDP )
ENTRY
Parameter Description
host <ip-addr>
<ip-addr>/<prefix>
<ip-addr>
<reverse-mask>
<dest-ip>
The destination addresses to match against. You can specify a
single host, a subnet, or all destination addresses. The following
are the valid formats for specifying the destination:
any
host <ip-addr>
<ip-addr>/<prefix>
<ip-addr>
<reverse-mask>
eq <0-65535>
Match on the specified source or destination TCP or UDP port
number.
vlan <1-4094>
The VLAN to match against. The ACL will match against the
specified ID in the packet's VLAN tag.
and enter the desired access-list name. This changes the prompt to
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Match a single source host with the
IP address given by <ip-addr> in
dotted decimal notation.
Match any source IP address within
the specified subnet. Specify the
subnet by entering the IPv4 address,
then a forward slash, then the prefix
length.
Match any source IP address within
the specified subnet. Specify the
subnet by entering a reverse mask
in dotted decimal format. For
example, entering "192.168.1.1
0.0.0.255" is the same as entering
192.168.1.1/24.
Match any destination IP address.
Match a single destination host with
the IP address given by <ip-addr> in
dotted decimal notation.
Match any destination IP address
within the specified subnet. Specify
the subnet by entering the IPv4
address, then a forward slash, then
the prefix length.
Match any destination IP address
within the specified subnet. Specify
the subnet by entering a reverse
mask in dotted decimal format. For
example, entering "192.168.1.1
0.0.0.255" is the same as entering
192.168.1.1/24.
ACL))
access-list hardware (named
access-list
796