Ipv6 Mld Immediate-Leave - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

MLD S C
NOOPING OMMANDS
6 -
IPV MLD IMMEDIATE LEAVE

ipv6 mld immediate-leave

Overview Use this command to minimize the leave latency of MLD memberships.
Use the no variant of this command to disable this feature.
Syntax ipv6 mld immediate-leave group-list <IPv6-access-list-name>
no ipv6 mld immediate-leave
Default Disabled
Mode Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Example The following example shows how to enable the immediate-leave feature on an
interface for a specific range of multicast groups. In this example, the router
assumes that the group access-list consists of groups that have only one node
membership at a time per interface:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
613-50157-01 Rev C
Parameter
<IPv6-access-
list-name>
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Description
Specify a Standard or an Extended software IPv6 access-list
name that defines multicast groups in which the
immediate leave feature is enabled.
See IPv6 Software Access Control List (ACL) Commands
supported IPv6 ACLs.
ipv6 enable
ipv6 mld immediate-leave v6grp
exit
for
738