Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 1062

AAA C
OMMANDS
AAA ACCOUNTING LOGIN
Usage This command enables you to define a named accounting method list. The items
that you define in the accounting options are:
•
•
You can define a default method list with the name default and any number of
other named method lists. The name of any method list that you define can then
be used as the <list-name> parameter in the
If the method list name already exists, the command will replace the existing
configuration with the new one.
There are two ways to define servers where RADIUS accounting messages are sent:
•
•
There is one way to define servers where TACACS+ accounting messages are sent:
•
The accounting event to send to the RADIUS or TACACS+ server is configured with
the following options:
•
•
•
Examples To configure RADIUS accounting for login shell sessions, use the following
commands:
awplus#
awplus(config)#
radius
To configure TACACS+ accounting for login shell sessions, use the following
commands:
awplus#
awplus(config)#
tacacs+
To reset the configuration of the default accounting list, use the following
commands:
awplus#
awplus(config)#
613-50157-01 Rev C
the types of accounting packets that will be sent
the set of servers to which the accounting packets will be sent
group radius : use all RADIUS servers configured by
command
group <group-name> : use the specified RADIUS server group configured
with the aaa group server
group tacacs+ : use all TACACS+ servers configured by
command
start-stop : sends a start accounting message at the beginning of a session
and a stop accounting message at the end of the session.
stop-only : sends a stop accounting message at the end of a session.
none : disables accounting.
configure terminal
aaa accounting login default start-stop group
configure terminal
aaa accounting login default start-stop group
configure terminal
no aaa accounting login default
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
accounting login
command
command.
radius-server host
tacacs-server host
1062