Boot System - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

F C M
ILE AND ONFIGURATION ANAGEMENT

BOOT SYSTEM

boot system
Overview Use this command to set the release file to load during the next boot cycle.
Use the no variant of this command to stop specifying a primary release file to boot
from. If the device boots up with no release file set, it will use autoboot or the
backup release file if either of those are configured, or you can use the boot menu
to select a release file source. To access the boot menu, type Ctrl-B at bootup.
boot system <filepath-filename>
Syntax
no boot system
Mode Global Configuration
Usage You can only specify that the release file is on a USB storage device if there is a
backup release file already specified in Flash. If you attempt to set the release file
on a USB storage device and a backup release file is not specified in Flash, the
following error message is displayed:
In a VCStack configuration, the stack only accepts a release file on a USB storage
device if a USB storage device is inserted in all stack members and all stack
members have a bootloader version that supports booting from it. If a stack
member has a USB storage device removed an error message is displayed. For
example, if stack member 2 does not have a USB storage device inserted the
following message is displayed:
Examples To boot up with the release FS980-5.4.7-0.1.rel file, which is stored on the device's
Flash filesystem, the next time the device boots up, use the commands:
awplus#
awplus(config)#
To run the release file FS980-5.4.7-0.1.rel, which is stored on the switch's USB
storage device filesystem, the next time the device boots up, use the commands:
awplus#
awplus(config)#
613-50157-01 Rev C
C
OMMANDS
Parameter
<filepath-filename>
% A backup boot image must be set before setting a current boot 
image on USB storage device
% Stack member 2 has no USB storage device inserted
configure terminal
boot system flash:/FS980-5.4.7-0.1.rel
configure terminal
boot system usb:/FS980-5.4.7-0.1.rel
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Description
Filepath and name of a release file.
The specified release file must exist and must be stored
in the root directory of the specified filesystem.
Valid release files must have a . rel extension.
80