Commit (Ipv4) - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

IP 4 H A C
V ARDWARE CCESS ONTROL
(IP 4)
COMMIT V

commit (IPv4)

Overview Use this command to commit the IPv4 ACL filter configuration entered at the
console to the hardware immediately without exiting the IPv4 Hardware ACL
Configuration mode.
This command forces the associated hardware and software IPv4 ACLs to
synchronize.
commit
Syntax
Mode IPv4 Hardware ACL Configuration
Usage Normally, when an IPv4 hardware ACL is edited, the new configuration state of the
IPv4 ACL is not written to hardware until you exit IPv4 Hardware ACL Configuration
mode. By entering this command you can ensure that the current state of a
hardware access-list that is being edited is written to hardware immediately.
Scripts typically do not include the
potentially leading to IPv4 ACL filters in hardware not being correctly updated.
Using this commit command in a configuration script after specifying an IPv4
hardware ACL filter ensures that it is updated in the hardware immediately.
Example To update the hardware with the IPv4 ACL filter configuration, use the command:
awplus#
awplus(config)#
awplus(config-ip-hw-acl)#
Related access-list hardware (named hardware ACL)
Commands
613-50157-01 Rev C
L (ACL) C
IST OMMANDS
configure terminal
access-list hardware my-hw-list
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
exit command to exit configuration modes,
commit
798