Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 780

IP 4 H A C
V ARDWARE CCESS ONTROL
( ACL: ICMP
NAMED HARDWARE
613-50157-01 Rev C
L (ACL) C
IST OMMANDS
)
ENTRY
Parameter Description
host <ip-addr>
<ip-addr>/<prefix> Match any source IP address within
<ip-addr>
<reverse-mask>
<dest-ip>
The destination addresses to match against. You can specify a
single host, a subnet, or all destination addresses. The following
are the valid formats for specifying the destination:
any
host <ip-addr>
<ip-addr>/<prefix> Match any destination IP address
<ip-addr>
<reverse-mask>
icmp-type
The type of ICMP message to match against, as defined in
<number>
RFC792 and RFC950. Values include:
0
3
4
5
8
11
12
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Match a single source host with the
IP address given by <ip-addr> in
dotted decimal notation.
the specified subnet. Specify the
subnet by entering the IPv4
address, then a forward slash, then
the prefix length.
Match any source IP address within
the specified subnet. Specify the
subnet by entering a reverse mask
in dotted decimal format. For
example, entering "192.168.1.1
0.0.0.255" is the same as entering
192.168.1.1/24.
Match any destination IP address.
Match a single destination host
with the IP address given by
<ip-addr> in dotted decimal
notation.
within the specified subnet.
Specify the subnet by entering the
IPv4 address, then a forward slash,
then the prefix length.
Match any destination IP address
within the specified subnet.
Specify the subnet by entering a
reverse mask in dotted decimal
format. For example, entering
"192.168.1.1 0.0.0.255" is the same
as entering 192.168.1.1/24.
Echo replies.
Destination unreachable
messages.
Source quench messages.
Redirect (change route) messages.
Echo requests.
Time exceeded messages.
Parameter problem messages.
780