R
C
OUTING
OMMANDS
6
SHOW IPV
ROUTE
show ipv6 route
Overview
Use this command to display the IPv6 routing table for a protocol or from a
particular table.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
Syntax
show ipv6 route [connected|database|summary|<ipv6-address>|
<ipv6-addr/prefix-length>)]
Mode
User Exec and Privileged Exec
Example 1
To display an IP route with all parameters turned on, use the following command:
awplus#
Output
Figure 20-4: Example output of the show ipv6 route command
613-50157-01 Rev C
Parameter
connected
database
summary
<ipv6-address>
<ipv6-prefix/length> Displays only the routes for the specified IP prefix.
show ipv6 route
IPv6 Routing Table
Codes: C - connected, S - static, R - RIP, O - OSPF, B - BGP
S
::/0 [1/0] via 2001::a:0:0:c0a8:a6, vlan10
C
2001:db8::a:0:0:0:0/64 via ::, vlan10
C
2001:db8::14:0:0:0:0/64 via ::, vlan20
C
2001:db8::0:0:0:0/64 via ::, vlan30
C
2001:db8::28:0:0:0:0/64 via ::, vlan40
C
2001:db8::fa:0:0:0:0/64 via ::, vlan250
C
2001:db8::/64 via ::, vlan250
C
2001:db8::/64 via ::, vlan40
C
2001:db8::/64 via ::, vlan20
C
2001:db8::/64 via ::, vlan10
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Description
Displays only the routes learned from connected
interfaces.
Displays only the IPv6 routing information extracted
from the database.
Displays summary information from the IPv6 routing
table.
Displays the routes for the specified address in the IP
routing table. The IPv6 address uses the format
X:X::X:X/Prefix-Length. The prefix-length is usually set
between 0 and 64.
"Getting Started
Guide.
643