Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 430

VLAN C
OMMANDS
SWITCHPORT TRUNK ALLOWED VLAN
Add VLAN 4 by re-entering the except parameter with a list of VLANs to exclude,
instead of using the add parameter to include VLAN 4, as shown in the command
example below:
awplus#
awplus(config)#
awplus(config-if)#
The configuration is changed after entering the above commands to add VLAN 4:
Examples The following shows adding a single VLAN to the port's member set.
awplus#
awplus(config)#
awplus(config-if)#
The following shows adding a range of VLANs to the port's member set.
awplus#
awplus(config)#
awplus(config-if)#
The following shows adding a list of VLANs to the port's member set.
awplus#
awplus(config)#
awplus(config-if)#
613-50157-01 Rev C
configure terminal
interface port1.0.5
awplus#show running-config

!

interface port1.0.5
switchport
switchport mode trunk
switchport trunk allowed vlan except 3,5
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
switchport trunk allowed vlan except 3,5
switchport trunk allowed vlan add 2
switchport trunk allowed vlan add 2-4
switchport trunk allowed vlan add 2,3,4
430