Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 833

IP 4 S A C
V OFTWARE CCESS ONTROL
( -
ACCESS LIST STANDARD NUMBERED FILTER
Usage An ACL can be configured with multiple ACL filters using sequence numbers. If the
sequence number is omitted, the next available multiple of 10 will be used as the
sequence number for the new filter. A new ACL filter can be inserted into the
middle of an existing list by specifying the appropriate sequence number.
NOTE
(standard numbered)
no further parameters selected.
Software ACLs will deny access unless explicitly permitted by an ACL action.
To add a new entry accepting the IP network 10.1.1.0/24 at the sequence
Example
number 15 position, use the commands:
awplus#
awplus(config)#
awplus(config-ip-std-acl)#
Related access-list (standard numbered)
Commands
show running-config
show ip access-list
613-50157-01 Rev C
L (ACL) C
IST OMMANDS
)
: The access control list being configured is selected by running the
command with the required access control list number but with
configure terminal
access-list 99
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
15 permit 10.1.2.0 0.0.0.255
access-list
833